17
DCS-3950 series Ethernet switch manual
Fig 2-3 Attaching power cable to DCS-3950 series
1. Insert one end of the power cable provided in the accessory kit into the power source
socket (with overload and leakage protection), and the other end to the power socket in
the back panel of the switch.
2. Check the power status indicator in the front panel of the switch. The corresponding
power indicator should light. DCS-3950 series is self-adjustable for the input voltage. As
soon as the input voltage is in the range printed on the switch surface, the switch can
operate correctly.
3. When the switch is powered on, it executes self-test procedure and startups.
Caution!
The input voltage must be within the required range, otherwise the switch could
malfunction of be damaged. Do not open the switch shell without permission. It can cause
physical injury
To Next Page
Loading...
Need help?
General