Digitalchina Networks DCS-3950 series User Manual

382
DCS-3950 series Ethernet switch manual
Displayed Information Notes
C - connected Directly connected routing.
S – static Static routing, which is manually configured.
R - RIP derived RIP routing, which is learned by Lay 3 switches through RIP
protocol.
O - OSPF derived OSPF routing, which is learned by Lay 3 switches, through the
OSPF protocol.
A- OSPF ASE OSPF-ASE routing.
B- BGP derived BGP routing
D - DVMRP derived DVMRP routing
Destination Destination network
Mask Destination network mask.
Nexthop IP address of next hop.
Interface The interface of Layer 3 switches for forwarding the packets to
next hop.
Preference Priority of the routing entry. If packets can reach the
destination network through more than one route, the route
with the highest priority will be chosen.
25.2 ARP
25.2.1 Introduction to ARP
ARP (Address Resolution Protocol) is mainly used in IP address to Ethernet MAC
address resolution. DCS-3950 series supports static configuration.
25.2.2 ARP Configuration
25.2.2.1 ARP Configuration Task List
1. Configure static ARP
1. Configure static ARP
Command Explanation
arp <ip_address> <mac_address>
no arp <ip_address>
Configure a static ARP entry; the ‘no arp
<ip_address>‘ command deletes a static
ARP entry.

Digitalchina Networks DCS-3950 series Specifications

General

Brand	Digitalchina Networks
Model	DCS-3950 series
Category	Network Router
Language	English