Digitalchina Networks DCS-3950 series User Manual

321
DCS-3950 series Ethernet switch manual
12. Set log record
19.2.2 DHCP Snooping Command List
19.2.2.1 ip dhcp snooping
Command：ip dhcp snooping enable
no ip dhcp snooping enable
Function： Enable the DHCP Snooping function.
Parameters：None.
Command mode：Globe Mode.
Default Settings：DHCP Snooping is disabled by default.
Usage Guide： When this function is enabled, it will monitor all the DHCP Server
packets of non-trusted ports.
Example：Enable the DHCP Snooping function.
Switch(Config)#ip dhcp snooping enable
19.2.2.2 ip dhcp snooping binding
Command：debug ip dhcp snooping binding
no debug ip dhcp snooping binding
Function：This command is use to enable the DHCP SNOOPING debug switch to debug
the state of binding data of DHCP SNOOPING.
Command mode：Admin Mode.
Default : DHCP snooping binding disabled by default
Usage Guide：This command is mainly used to debug the state of DHCP SNOOPING
task when it adds ARP list entries, dot1x users and trusted user list entries according to
binding data.
Example: Enable binding for DHCP snooping.
Debug ip dhcp snooping packet
Debug ip dhcp snooping event
Debug ip dhcp snooping update
Debug ip dhcp snooping binding
Please refer to the system debugging
chapter.
Command Explanation
Admin Mode
Login on
logging source {default|
m_shell|sys_event|anti_attack} channel
{ console | logbuff | loghost | monitor }
[ level { critical | debugging | notifications |
warnings } [state { on | off } ] ]
Please refer to the chapter on
system log

Digitalchina Networks DCS-3950 series Specifications

General

Brand	Digitalchina Networks
Model	DCS-3950 series
Category	Network Router
Language	English