34
DCS-3950 series Ethernet switch manual
shown below:
cmdtxt <variable> { enum1 | … | enumN } [option]
Conventions: cmdtxt in bold font indicates a command keyword; <variable> indicates a
variable parameter; {enum1 | … | enumN } indicates a mandatory parameter that should
be selected from the parameter set enum1~enumN; and the square bracket ([ ]) in
[option] indicate an optional parameter. There may be combinations of ‘< >‘, ‘{ }’ and ‘[ ]’ in
the command line, such as [<variable>],{enum1 <variable>| enum2}, [option1
[option2]], etc.
Here are examples for some actual configuration commands:
z show version， no parameters required. This is a command with only a keyword and
no parameter, just type in the command to run.
z vlan <vlan-id>， parameter values are required after the keyword.
z speed-duplex {auto | force10-half | force10-full | force100-half | force100-full |
{{force1g-half | force1g-full} [nonegotiate [master | slave]] } }，the followings are
possible:
speed-duplex auto
speed-duplex force10-half
speed-duplex force10-full
speed-duplex force100-half
speed-duplex force100-full
speed-duplex force1g-half
speed-duplex force1g-half nonegotiate
speed-duplex force1g-half nonegotiate master
speed-duplex force1g-half nonegotiate slave
speed-duplex force1g-full
speed-duplex force1g-full nonegotiate
speed-duplex force1g-full nonegotiate master
speed-duplex force1g-full nonegotiate slave
z snmp-server community {ro|rw} <string>， command options are presented as
below:
snmp-server community ro <string>
snmp-server community rw <string>
4.2.1.3 Shortcut Key Support
DCS-3950 series switch provides several shortcut keys to facilitate user configuration,
such as up, down, left, right and Blank Space. If the terminal does not recognize Up and
Down keys, ctrl +p and ctrl +n can be used instead.
Key(s) Function
To Next Page
Loading...
Need help?
General