208
DCS-3950 series Ethernet switch manual
<vlan-id>‘ command will disable the IGMP
Snooping function of the multicast vlan.
ip igmp snooping
no ip igmp snooping
Start the IGMP Snooping function. The ‘no
ip igmp snooping‘ command will disable the
IGMP Snooping function globally.
12.2.2 Multicast VLAN Configuration Command List
12.2.2.1 multicast-vlan
Command: multicast-vlan
no multicast-vlan
Function: Enable multicast VLAN function on a VLAN; the ‘no’ form of this command
disables the multicast VLAN function.
Parameter: None
Command mode: VLAN configuration mode
Default: Multicast VLAN function not enabled by default
Usage Guide: The multicast VLAN function can not be enabled on private VLAN. To
disable the multicast VLAN function of the VLAN, configuration of VLANs associated with
the multicast VLAN should be deleted. Note that the default vlan can not be configured
with this command and only one multicast vlan is allowed on a switch
Examples:
Switch(config)#vlan 2
Switch (Config-Vlan2)# multicast vlan
12.2.2.2 multicast-vlan association <vlan-list>
Command: multicast-vlan association <vlan-list>
no multicast-vlan association <vlan-list>
Function: Associate several VLANs with a multicast VLAN; the ‘no’ form of this command
cancels the association relations.
Parameter: <vlan-list> the VLAN ID list associated with multicast VLAN. Each VLAN can
only be associated with one multicast VLAN and the association will only succeed when
every VLAN listed in the VLAN ID table exists.
Command mode: VLAN Mode
Default: The multicast VLAN is not associated with any VLAN by default
Usage Guide: After a VLAN is associated with the multicast VLAN, when there comes the
multicast order in the port of this VLAN, then the multicast data will be sent from the
multicast VLAN to this port, so to reduce the data traffic. The VLAN associated with the
multicast VLAN should not be a Private VLAN. A VLAN can only be associated with
another VLAN after the multicast VLAN is enabled. Only one multicast VLAN can be
enabled on a switch.
Examples: