111
DCS-3950 series Ethernet switch manual
Command mode: Global Mode
Usage Guide: When this command is executed in the commander switch and the
commander switch receives the cluster register packets sent by the new switch, the
commander switch adds the candidate switch to the cluster. If this command is executed
in a non-commander switch, an error will be displayed.
Example: Enable the auto adding function in the commander switch.
Switch(config)#cluster auto-add enable
6.2.2.7 rcommand member
Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> is the cluster ID of the member switch, valid rang is 1 to 23.
Default: None.
Command mode: Admin Mode.
Usage Guide: Enter the Admin Mode of the member switch and configure the member
switch remotely. Use ‘exit’ to quit the configuration interface of the member switch. If this
command is executed in a non-commander switch, an error will be displayed.
Example: In the commander switch, enter the configuration interface of the member
switch with mem-id 15.
Switch#rcommand member 15
6.2.2.8 rcommand commander
Command: rcommand commander
Function: In the member switch, use this command to manager and configure the
commander switch remotely.
Parameter: None
Default: None.
Command mode: Admin Mode.
Usage Guide: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The command ‘exit’ is
used to quit the configuration interface of the commander switch. If this command is
executed in the commander switch, an error will be displayed.
Example: In the member switch, enter the configuration interface of the commander
switch.
Switch#rcommand commander
6.2.2.9 cluster reset member
Command: cluster reset member <mem-id>
Function: In the commander switch, this command can be used to reset the member
switch.
To Next Page
Loading...
Need help?
General