134
DCS-3950 series Ethernet switch manual
Interface Link/Protocol Speed Duplex Vlan Type Alias Name
0/0/1 UP/UP f-100M f-full 1 G-TX
0/0/2 UP/UP a-100M a-full trunk G-TX
0/0/3 UP/DOWN auto auto 1 G-TX
0/0/4 A-Down/DOWN auto auto 1 G-TX
information
showed
meaning
Interface Detail port number, no Ethernet prefix.
Link/Protocol Port and protocol connect status, UP or DOWN, with ‘/’ in middle.
A-DOWN in link means administratively down.
Speed Port speed, the format is mode-rate. Mode a means auto mode. At
auto mode, the rate following is auto negotiation rate. If port protocol is
DOWN, then here is auto only. Mode F means force mode, the rate
following is forced set rate.
Duplex Duplex status, show format is mode-duplex status. Mode A means
auto mode, f means force mode. Duplex status is full or half.
Vlan When port is access port, this means the Vlan, and when port is trunk
port, this shows trunk.
Type Hardware type. At present the hardware types are SFP, G-USB, G-TX,
G-Combo, GBIC, XGE GBIC, FE. The bottom of table will show G is
Gigabit. When port type is Combo, and port up without loop, it will
show the active port is copper or fiber after the hardware type.
Alias Name Port name set by user. If not set, it will show blank. If more than 15
byte, then show only first 15 byte.
7.4.1.4 show interface ethernet counter packet
Command：show interface ethernet counter packet
Function：Show all Ethernet port packet counter information.
Parameters：None.
Command mode：Admin Mode
Usage Guide：This command show input and output L2 uni-cast, multicast, broadcast and
error packet counter. For each port there will be two lines, the first line for input packet,
and second line for output.
Example：Show packet counter information:
Switch#show interface ethernet counter packet
Interface Unicast(pkts) BroadCast(pkts) MultiCast(pkts) Err(pkts)
0/0/1 IN 12,345,678 12,345,678,9 12,345,678,9 4,567
OUT 23,456,789 34,567,890 5,678 0
0/0/2 IN 0 0 0 0
OUT 0 0 0 0
0/0/3 IN 0 0 0 0
OUT 0 0 0 0
To Next Page
Loading...
Need help?
General