150
DCS-3950 series Ethernet switch manual
-------------------------------------------------------------------------------------------------------
Total Addresses :1
Items Notes
Vlan The VLAN ID for the secure MAC Address
Mac Address Secure MAC address
Type Secure MAC address type
Ports The port that the secure MAC address belongs to
Total Addresses Current secure MAC address number in the system.
8.5.1.3.2 MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some
possible causes and solutions:
& If MAC address binding cannot be enabled for a port, make sure the port is not
enabling Spanning tree or port aggregation and is not configured as a Trunk port.
MAC address binding is exclusive to such configurations. If MAC address binding is
to be enabled, the functions mentioned above must be disabled first.
& If a secure address is set as static address and deleted, that secure address will be
unusable even though it exists. For this reason, it is recommended to avoid static
address for ports enabling MAC address
& Users might find that some devices connected to the ports configured with MAC
address binding function can not transmit data. If so, please check whether the MAC
addresses of these devices has been transformed into secure MAC, if not, even the
switch has learnt the MAC addresses of these devices, they can not transmit data,
because only secure MAC can transmit data when the ports has enabled the MAC
address binding function.