To Next Page

To Previous Page

229

DCS-3950 series Ethernet switch manual

Command mode: Global Mode

Default: AAA accounting is not enabled by default.

Usage Guide:

When accounting is enabled in the switch, accounting will be performed according to

the traffic or online time for port the authenticated user is using. The switch will send an

‘accounting started’ message to the RADIUS accounting server on starting the

accounting, and an accounting packet for the online user to the RADIUS accounting

server every five seconds, and an ‘accounting stopped’ message is sent to the RADIUS

accounting server on accounting end. Note: The switch send the ‘user offline’ message

to the RADIUS accounting server only when accounting is enabled, the ‘user offline’

message will not be sent to the RADIUS authentication server.

Example: Enabling AAA accounting for the switch.

Switch(Config)#aaa-accounting enable

14.2.2.3 aaa-accounting update enable

Command: aaa-accounting update {enable|disable}

no aaa-accounting update {enable|disable}

Function: Enable or disable update for AAA accounting.

Command mode: Global Mode.

Default: AAA accounting is enabled by default.

Usage Guide: If the AAA accounting is enabled, the switch will send out accounting

messages peroidically to the accounting server for every online users.

Example: Disable periodic the AAA account.

Switch(Config)#aaa-accounting update disable

14.2.2.4 dot1x accept-mac

Command: dot1x accept-mac <mac-address> [interface <interface-name>]

no dot1x accept-mac <mac-address> [interface <interface-name>]

Function: Add a MAC address entry to the dot1x address filter table. If a port is specified,

the entry added applies to the specified port only. If no port is specified, the entry added

applies to all the ports. The ‘no dot1x accept-mac <mac-address> [interface

<interface-name>]’ command deletes the entry from dot1x address filter table.

Parameters: <mac-address> stands for MAC address; <interface-name> for interface

name and port number.

Command mode: Global Mode

Default: None.

Usage Guide:

The dot1x address filter function is implemented according to the MAC address filter

table, dot1x address filter table is manually added or deleted by the user. When a port is

specified in adding a dot1x address filter table entry, that entry applies to the port only;

when no port is specified, the entry applies to all ports in the switch. When dot1x address

filter function is enabled, the switch will filter the authentication user by the MAC address.

Digitalchina Networks DCS-3950 series User Manual

Questions and Answers: