337
DCS-3950 series Ethernet switch manual
21.2.2.3 anti-arpscan ip-based threshold <threshold-value>
Command：anti-arpscan ip-based threshold <threshold-value>
no anti-arpscan ip-based threshold
Function：Set the threshold of received messages of the IP-based ARP scanning
prevention. If the rate of received ARP messages exceeds the threshold, the IP
messages from this IP will be blocked. The unit is packet/second. The ‘no anti-arpscan
ip-based threshold’ command will reset the default value, 3 packets per second.
Parameters：rate threshold, ranging from 2 to 200.
Default：3 packets per second
Command mode：Global Mode
User Guide：the threshold of port-based ARP scanning prevention should be larger than
the threshold of IP-based ARP scanning prevention, or, the IP-based ARP scanning
prevention will fail.
Example：Set the threshold of IP-based ARP scanning prevention as 6 packets per
second.
Switch(Config)#anti-arpscan port-based threshold 6
21.2.2.4 anti-arpscan trust <port|supertrust-port>
Command：anti-arpscan trust <port | supertrust-port>
no anti-arpscan trust <port | supertrust-port>
Function：Configure a port as a trusted port or a super trusted port;’ no anti-arpscan trust
<port | supertrust-port>‘command will reset the port as an untrusted port.
Parameters：None.
Default：By default all the ports are non- trustful.
Command mode：Port Mode.
User Guide：If a port is configured as a trusted port, then the ARP scanning prevention
function will not deal with this port, even if the rate of received ARP messages exceeds
the set threshold, this port will not be closed, but the non- trustful IP of this port will still be
checked. If a port is set as a super non- trustful port, then neither the port nor the IP of
the port will be dealt with. If the port is already closed by ARP scanning prevention, it will
be opened right after being set as a trusted port.
Example：Set port ethernet 1/5 of the switch as a trusted port
Switch(Config)#interface ethernet 0/0/5
Switch(Config-if-ethernet 0/0/5)# anti-arpscan trust port
21.2.2.5 anti-arpscan trust ip <ip-address> [<netmask>]
Command：anti-arpscan trust ip <ip-address [<netmask>]>
no anti-arpscan trust ip <ip-address [<netmask>]>
Function ： Configure trusted IP;’ no anti-arpscan trust ip
<ip-address[<netmask>]>‘command reset the IP to non-trustful IP.
Parameters：Net mask of the IP
To Next Page
Loading...
Need help?
General