EasyManuals Logo

Digitalchina Networks DCS-3950 series User Manual

Digitalchina Networks DCS-3950 series
394 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #377 background imageLoading...
Page #377 background image
367
DCS-3950 series Ethernet switch manual
trust DSCP value; port priority <cos> assigns a priority to the physical port, cos is the
priority to be assigned.
Default: No trust.
Command mode: Interface Mode
Example: Configure Ethernet port 0/0/1 to trust CoS value, i.e., classifying the packets
awitch(ccording to CoS value, DSCP value should not be changed.
Sconfig)#interface ethernet 0/0/1
Switch(Config-Ethernet0/0/1)#mls qos trust cos
24.2.2.11 mls qos cos
Command: mls qos cos {<default-cos> }
no mls qos cos
Function: Configure the default CoS value of the port; the ‘no mls qos cos’ command
restores the default setting.
Parameters: < default-cos> is the default CoS value for the port, the valid range is 0 to 7.
Default: The default CoS value is 0.
Command mode: Interface Mode
Usage Guide: none
Example: Set the default CoS value of Ethernet port 1/1 to 5, i.e., packets coming in
through this port will be assigned a default CoS value of 5 if no CoS value present.
Switch(config)#interface ethernet 0/0/1
Switch(Config-Ethernet0/0/1)#mls qos cos 5
24.2.2.12 service-policy
Command: service-policy {input <policy-map-name>|output <policy-map-name>}
no service-policy {input <policy-map-name>|output
<policy-map-name>}
Function: Apply a policy map to the specified port; the ‘no service-policy input
<policy-map-name>‘ command deletes the specified policy map applied to the port.
Parameters: input <policy-map-name> applies the specified policy map to the ingress
of switch port.
Default: No policy map is bound to ports by default.
Command mode: Interface Mode
Usage Guide: Configuring port trust status and applying policy map on the port are two
conflicting operations; the later configuration will override the earlier configuration. Only
one policy map can be applied to each direction of each port. Egress policy map is not
supported yet.
Example: Bind policy p1 to ingress Ethernet port 0/0/1
Switch(config)#interface ethernet 0/0/1
Switch(Config-Ethernet0/0/1)# service-policy input p1
24.2.2.13 mls qos dscp-mutation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digitalchina Networks DCS-3950 series and is the answer not in the manual?

Digitalchina Networks DCS-3950 series Specifications

General IconGeneral
BrandDigitalchina Networks
ModelDCS-3950 series
CategoryNetwork Router
LanguageEnglish