Dionex ASE 150 - Safety and Regulatory Information; Safety Labels

1 • Introduction
Doc. 065207-02 9/08 5
1.3 Safety and Regulatory Information
The ASE 150 was manufactured by Dionex Corporation at the following location:
527 Lakeside Drive, Sunnyvale, CA 94088-3603 U.S.A. The ASE 150 is designed
for solvent extraction applications and should not be used for any other purpose.
Operation of an ASE 150 in a manner not specified by Dionex may result in
personal injury.
If you have a question regarding appropriate usage, contact Dionex before
proceeding. In the U.S., call 1-800-346-6390 and select the Technical Support
option. Outside the U.S., call the nearest Dionex office.
1.4 Safety Labels
The cTUVus Mark safety label and the CE Mark label on the ASE 150 indicate
that the ASE 150 is in compliance with the following standards.
EMC Susceptibility and Emissions
• EN 61326-1:2006
Safety
• CAN/CSA-C22.2 No. 61010-1:2004
• EN 61010-1:2001
• UL 3101-1/10.93
• UL 61010-1:2004
The symbols below appear on the ASE 150 or on ASE 150 labels.
Alternating current
Primary protective conductor terminal
Secondary protective conductor terminal