DIS DDS 5900 - Audio Control Commands

Danish Interpretation Systems User Manual
10.2.2.11
10.2.2.12
10.2.2.13
Microphone status complete
mic_status_done<CR>
nforms,thatcompletesystemstatushasbeensent.I

Seat state
seat_state<seatnumber><seatstate><CR>
Seatstateinformation.
ThisinformationissentfromtheCUtoanexternalcontrolapplication,whenthestateofaseatchanges–aseat
ecomespassib veoractive.
seatnum gerrangingfrom1to65535.< ber>Theseatnumberidentificationofaconferenceunit.Aninte
seatstate>Thecurrentstateoftheseat.Thiscanbe"active"or"passive"<

Command error
command_error<errortext><CR>
TheCUhasreceivedanunknowncommand.
<errortext>isatextexplainingthefaultcase.
Examples:
command_errorunknowncommand<CR>
command_errorsyntaxerror<CR>

10.3 Audio Control
10.3.1 Commands from External Control to CU 5905
10.3.1.1
10.3.1.2
Set loudspeaker volume
loudspeaker_volume<volume><CR>
tthevoSe lumeofloudspeakersforallconferenceunits.
<volume>Thevolumeoftheloudspeakersrangingfrom‐41to0.Thevalue‐41indicatesOff,whereasvaluesfrom‐
40to0indicatesattenuationindB.
heCUrespondstothiscommandbyreturninga‘loudspeaker_volume’command.T

Set line input 1 level
line_input_level_1<level><C
Adjusttheleveloflineinputsignal.
R>
User Manual DDS 5900
52