DIS DDS 5900 - User Manual DDS; 10.3.2 Commands from CU 5905 to External Control

Danish Interpretation Systems User Manual
<level>Theleveloflineinput1rangesfrom‐41to0.Thevalue‐41indicatesOff,whereasvaluesfrom‐40to0
indicatesattenuationindB.
heCUrespondstothiscommandbyreturninga‘line_input_level_1’command.T

10.3.1.3
10.3.1.4
10.3.1.5
Set line output volume (A-D)
line_output_volume<output><
Adjusttheleveloflineoutputsignal.
output>
volume><CR>
< Indicateswhichoutputisbeingcontrolled.Possiblevalues:‘A’,‘B’,‘C’,‘D’.
<volume>Thevolumeoflineoutputrangesfrom‐41to0.Thevalue‐41indicatesOff,whereasvaluesfrom‐40to0
indicatesattenuationindB.
heCUrespondstothiscommandbyreturninga'line_output_volume'command.T

Define audio path
audio_path<path><on/off><CR>
hiscomm io s tT anddefinesaud connection inthesys em.
<path> Indicates which connection is being controlled. Possible values: 'mic_to_speaker', 'mic_to_floor',
nein_1'li _to_speaker','linein_1_to_lineout_A',‘linein_1_to_floor’.
edfrommic neinput_1tospeakers/lineoutput/floor.<on/off>Indicates,whethertheaudioisbeingrout rophones/li
heCUrespondstothiscommandbyreturningan‘audio_path’command.T

Request audio status
audio_status<CR>
Systemaudiostatus.
heCUrespondstothiscommandbyreturningalistofcommandsfortheAudiosettings:T
 loudspeaker_volume
line_output lloutputsA‐D) _volume(fora
 audio_path(forallpaths)

 audio_status_done
line_input_level
10.3.2 Commands from CU 5905 to External Control
10.3.2.1 Loudspeaker volume
loudspeaker_volume<volume><CR>
Volumeofloudspeakersforallconferenceunits.
User Manual DDS 5900
53