Using Charging Hub as a Power Bank
1. Insert one or more batteries into the charging hub. Connect an external device, such
as a smartphone or remote controller to the USB-C port of the charging hub, and then
press and hold the function button for three seconds.
2. Batteries will be discharged based on the battery level, from the lowest to the
highest, and supply power to the external device. To stop charging the external device,
disconnect the external device from the charging hub.
• If the remaining charge of a battery is lower than 7%, the battery cannot charge
the external device.
Accumulating Power
1. Insert the Intelligent Flight Batteries into the charging hub, press and hold the
function button to transfer the power from the batteries with a lower power level
to the battery with the highest power level. The status LEDs for the batteries with a
lower power level will display the current power level, while the status LEDs for the
battery with a high power level will blink in sequence.
2. To stop accumulating power, press and hold the function button again. After stopping
power accumulation, press the function button to check the power level of the
batteries.
DJI Flip User Manual
60 © 2025 DJI All Rights Reserved.
To Next Page
Loading...
