dji FLIP - Page 61

10% 30% 10%
3s
• Power accumulation stops automatically in the following situations:
◆
The receiving battery is fully charged, or the power of the output battery is
lower than 10%.
◆
A charger or external device is connected to the charging hub or any battery
is inserted or withdrawn from the charging hub during power accumulation.
◆
Power accumulation is interrupted for more than 15 minutes due to
abnormal battery temperature.
• After accumulating power, charge the battery with the lowest power level as
soon as possible to avoid discharge.
Status LEDs Descriptions
Each battery port of the charging hub has its corresponding status LED array, which can
indicate charging status, battery level and abnormal status. The LED status for battery
level and battery abnormality is the same as that on the aircraft.
Charging Status
Blinking Pattern Descriptions
Status LEDs in an array
blink quickly successively
The battery in the corresponding battery port is being
charged using a USB PD charger.
Status LEDs in an array
blink slowly successively
The battery in the corresponding battery port is being
charged using a normal charger.
Status LEDs in an array are
solid
The battery in the corresponding battery port is fully
charged.
All status LEDs blink in se-
quence
No battery is inserted.
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 61