6400-065-C-1-09
18
6003 “Opening to the Outside”
47.5” Open Position
7”
Addition to
support bracket
must be
fabricated to
reach wall.
Gate Hinge Pivot Point
Front Bracket
Pivot Point
Gate in Closed Position
Rear Bracket Pivot Point
Closed Position
Open Position
Actuator arm and brackets MUST be level!
A support bar must span
the entire length of the
gate to support the gate
pickets. The pickets will
bend if not supported.
Support Bar
90°
7”
Rear Bracket
Do not install the
actuator in fully
extended (Bottomed out)
position. This will
damage the arm. See
next page to prevent this
from happening.
Lock Washers
(Not Supplied)
Front Bracket
Bolt to support bar.
Bolt support bracket to
fabricated steel plate
with supplied lock nuts.
ttaching Brackets
The brackets must be securely mounted and level.
Sleeve Anchors
(Not Supplied)
Support
Bracket
(Supplied)
Fabricated
Reinforced
Steel Plates
(Not Supplied)
Front Bracket
Cut Off
Excess
Bracket
Cut Off
Excess
Bracket
A rear bracket will need to be fabricated.
The bracket will vary in size depending
on the gate hinge inset. It can be
attached to the wall by welding or
bolting, depending on the type wall. The
bracket MUST be level and VERY
secure to the wall. Extreme force will
be exerted on this bracket during gate
cycling.
Rear Bracket
Fabrication
To Next Page
Loading...
