Maintenance Section
144
5. Fasten lift chains, of equal length, in lift
openings in the front of the lift truck.
6. Slowly lift the front of the lift truck, until the drive
wheels are just off the ground.
7. Put stands under the frame. Remove the
tension on the lift chains.
8. Remove the battery.
9. Remove the floor plate.
NOTICE
Do not move directional lever from one direction to
the other when the drive wheels are off the ground
and rotating.
Damage can be caused to the control panel.
WARNING
Battery voltage and high amperage are present.
The power modules must be discharged before
any contact with the control panel is made.
Personal injury could result if it has not been
discharged properly.
10. Blow off the drive motor end shield with 205
kPa (30 psi) maximum air pressure, until dust is
removed from the motor.
11. Install the floor plate.
12. Slowly lift the front of the lift truck and remove
the stands. Lower the lift truck to the floor.
Remove the chains.
13. Install and connect the battery. Lower the
battery cover and adjust the seat.
To Next Page
Loading...
