Maintenance Section
130
Mast Channels - Lubricate
The channels on the roller-type mast require a
break-in period. Apply a light film of lubricant on the
channels where the rollers ride. This will prevent
metal peel until the rollers set a pattern.
Battery - Check, Exchange,
Change
Battery Access
Park the lift truck level, with the forks lowered and
the mast tilted forward until the fork tips touch the
floor.
1. Tilt the steering column to the full upright
position and move the seat fully rearward.
2. Release the hood latch lever which retain the
seat and battery cover.
3. Turn the attachment operator lever cover.
4. Raise the seat and battery cover.
[OUTSIDE BATTERY CONNECTOR]
[INSIDE BATTERY CONNECTOR]
5. Disconnect the battery.
To Next Page
