Operation Section
71
Lift Truck Controls
Parking Brake
NOTICE
Do not operate the emergency switch while the
forklift is in motion, unless in an emergency case.
Using the parking brake in place of the service
brake damages the parking brake severely.
Parking brake activation - The parking
brake is automatically engaged with a
“clunk” after the vehicle stops.
Release of parking brake - press the
accelerator pedal lightly to release the
parking brake
.
Service Brake Pedal
Service Brake - The service brake pedal is located
on the floor of the operator’s compartment.
Depress the service brake pedal to slow
or stop the lift truck. Drive circuit will be
interrupted while the pedal is depressed.
Release the service brake pedal to allow
the lift truck to move.
Accelerator Pedal
NOTICE
The service brake and accelerator pedals should
not be used at the same time, except for
emergency situations. Use of both the brake and
accelerator pedals at the same time may cause the
drive motor to overheat.
Accelerator Pedal - The accelerator pedal is
located on the floor of the operator’s compartment.
Push down the pedal to increase travel speed.
If the accelerator pedal is pressed before turning
the key switch to ON, "EE" error will be displayed
and the alarm buzzer will sound. Release the foot
and step on the pedal again to move the lift truck.
Release the pedal to decrease travel speed.
To Next Page
Loading...
