Maintenance Section
149
Every 2000 Service Hours or Yearly
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.
Hydraulic, Power Steering System
Change Oil and Filter Element
1. Operate the lift truck a few minutes to warm the
oil.
Park the lift truck level, with the forks lowered,
parking brake engaged, directional control
forward/reverse switch in NEUTRAL and the key
switch to OFF.
2. Remove the hydraulic tank drain plug. Allow the
oil to drain. Clean and install the plug.
3. Remove an discard the hydraulic filter.
4. Remove the breather / dipstick and the strainer.
Wash them in clean, nonflammable solvent and
dry them.
5. Install the strainer. Fill the hydraulic tank. See
āRefill Capacities.ā Install the dipstick.
6. Turn the key switch to ON and close the seat
switch. Operate the hydraulic controls and
steering system through a few cycles, to fill the
filter and lines.
To Next Page
Loading...
