Operation Section
49
Audio System (Radio/USB Player/Bluetooth)
Precaution
Safety information
WARNING
To reduce the risk of fire or electric shock, do
not expose this product to rain or moisture.
To reduce the risk of fire or electric shock and
annoying interference, use only the included co
mponents.
Handling precautions for safety
Do not operate any function that takes your
attention away from safely driving your vehicle.
Any function that requires your prolonged attention
should only be performed after coming to a
complete stop. Always stop the vehicle in a safe
location before performing these functions. Failure
to do so may result in an accident.
Keep the volume at a level where you can still hear
outside noises while driving.
Excessive volume levels that obscure sounds such
as emergency vehicle sirens or road warning
signals (train crossings, etc.) can be dangerous
and may result in an accident. Listening at loud
volume levels in a car may also cause hearing
damage.
Minimize display viewing while driving.
Viewing the display may distract the driver from
looking ahead of the vehicle and cause an
accident.
Do not disassemble or alter.
Doing so may result in an accident, fire or electric
shock.
Do not block vents or radiator panels.
Doing so may cause heat to build up inside and
may result in fire.
When driving
Keep the volume level low enough to be aware of
road and traffic conditions.
When washing your car
Do not expose the product, including the speakers
and USB device, to water or excessive moisture.
This could cause electrical short, fire, or other
damage.
When parked
Parking in direct sunlight can produce very high
temperatures inside your car. Give the interior a
chance to cool down before switching the unit on.
Use the proper power supply
This product is designed to operate with a DC 14.4
V or 28.8 V, negative-ground battery system.
Use authorized service centers
This product is made of precision parts. Do not
attempt to disassemble or adjust any parts. Please
refer to the Service Center list included with this
product for service assistance.
For installation
This product should be installed in a horizontal
position with the front end up at a convenient
angle, but not more than 30°.
NOTE: The preset memory is cleared to return to
the original factory setting when the power
connector or battery is disconnected.
This unit is designed for DC 14.4 V or 28.8 V
negative- ground vehicles only. Do not use a non-
standard power supply.
Do not use gasoline, thinner, benzene, organic
solvent, etc., to clean the unit.
Do not forcibly press function buttons. By
pressing lightly, damage can be avoided.
To Next Page
Loading...
