Operation Section
42
Seat Belt Switch
The seat belt switch is located next to the
operator’s seat.
OPEN - If the operator does not wear the
seat belt, the electric circuit will cut off.
CLOSE – When the operator wears the
seat belt, the electric circuit is connected.
When the key switch is turned ON and
turned to the CLOSE position, and the seat belt
switch is turned to the CLOSE position, the power
steering pump motor can be operated.
NOTE: If the operator wears and fastens the seat
belt before sitting on the seat, it is
recognized as a sequence error, the “E8”
error is displayed on the display and the
buzzer is activated. In order for the forklift to
be in normal waiting state, the seat belt
must be released and then put on again.
Lift Neutral Sensor
The lift neutral sensor is located in the main control
valve at the bottom of the operating lever.
If the lift lever is not neutral when the forklift is
started or the operator returns to the forklift, the lift
neutral sensor detects and FL error is displayed.
The lift neutral sensor and detection unit must be
adjusted so that they do not overlap and are not
sensed in neutral
To Next Page
Loading...
