Maintenance Section
151
4. Remove the locknut, lockwasher and flat
washer. Remove the outer wheel bearing.
5. Remove the wheel assembly. Examine the
wheel for damage and wear. Replace the wheel
if necessary.
6. Install the steer wheel. Put two nuts opposite
each other (180°). Tighten both. Install all
remaining nuts. Tighten all nuts in a crisscross
sequence opposite each other (180°) to a
torque of 140 N·m (105 lb·ft).
7. While rotating the wheel, tighten the locknut to
34 N·m (24 lb·ft). Loosen the nut completely.
Tighten the nut again to a torque of 11±3 N·m
(8±2 lb·ft) and lock within this range. Install the
cover.
8. Raise the lift truck and remove the blocking.
Lower the lift truck to the floor.
To Next Page
Loading...
