General Section
40
Mast Abbreviations
The identification plate indicates the type of mast
installed on the lift truck when it left the factory. The
type of mast is indicated by an abbreviation.
STD - Standard Mast(single inner member, low
free lift).
FF - Full Free Mast (single inner member,
high free lift with primary cylinder).
FFT - Triple Lift Mast (two inner members,
high free lift with primary cylinder).
QUAD - Quadruple(Quad) Mast(three inner
members, high free lift with primary
cylinder).
SPEC - Special Mast, such as non-telescopic or
double mast, not within the other
classifications.
When only a mast-type is listed on the identification
plate, a standard carriage and forks are used.
Attachment Abbreviations (includes
Special Forks)
SC - Special Carriage-increased width, height
or outreach.
SSS - Shaft-type Sideshift Carriage.
HSS - Hook-type Sideshift Carriage(ITA).
ISS - Integral type Sideshift Carriage.
ISFP - Integral Shifting type Fork Positioner.
CW - Special Counterweight.
SF - Special Forks.
Numbers following this abbreviation indicate
number and/or length of forks.
SS - SWS-Sideshift-Swing Shift.
RAM - Ram or Boom
ROTC - Rotating Carriage.
DBCBH - Double Cube Block Handler
HFP - Hydraulic Fork Positioner, Non Sideshift.
CR - Crane Arm or Crane Boom.
TH - Tire Handler.
CTH - Container Top Handler.
CSH - Container Side Handler
LP - Load Push Device, Non Sideshift.
LPP - Load Push-Pull Device, Non Sideshift.
C - General Clamp (other than Bale, Carton
or Roll).
BC - Bale Clamp.
CC - Carton Clamp.
RC - Roll Clamp.
LS - Load Stabilizer.
LH - Log Handler.
PWH - Pulp Wood Handler.
SS-ST - Sideshift-Side Tilt Carriage.
To Next Page
Loading...
