Safety Section
6
General Warnings to Operator
WARNING
Only trained and authorized personnel may
operate this machine. For safe operation, read
and follow the operation and maintenance
Manual furnished with this lift truck and observe
the following warnings :
1. Before starting machine. Check all controls
and warning devices for proper operation.
2. Refer to machine identification plate for
allowable machine capacity. Do not overload.
Operate machines equipped with
attachments as partially loaded machines
when not handling a load.
3. Put directional control or shift lever in
neutral before "ON-OFF" switch is turned on.
4. Start, turn and brake smoothly. Slow down
for turns, slippery or uneven surfaces.
Extremely poor surfaces should be repaired.
Avoid running over loose objects or holes in
the roadway surfaces. Use extreme caution
when turning on inclines.
5. Travel with load as low as possible and tilted
back. If load interferes with visibility, travel
with load trailing.
6. On grade operations travel with load up
grade.
7. Watch out for pedestrians and obstructions.
Check overhead clearances.
8. Do not permit riders on forks or machine at
any time.
9. Do not allow anyone to stand or pass under
the elevated portion of any machine.
10. Be sure operating surface can safely support
machine.
11. Operate machine and attachments only from
operator's position.
12. Do not handle unstable or loosely stacked
loads.
13. Use minimum tilt when picking up or
depositing a load.
14. Use extreme care when handling long, high
or wide loads to ensure stability and
durability of the truck.
15. Forks should be completely under load and
spread apart as far as load permits.
16. Machine should be equipped with overhead
guard or equivalent protecti
on. Where load
requires it, use load backrest extension. Use
extreme caution if operating without these
devices.
17. Lower the lifting fork on the floor for parking
the truck. Set the forward/reverse switch at
neutral. Check that parking brake lamp is on,
and turn the ignition switch to OFF position.
Chock the wheels when parking the truck on
a slope. Disconnect battery when parking an
electric lift truck.
18. When charging the batteries of an electric
forklift, observe safety instruction.
19. The emergency switch uses in emergency
really. When you use often emergency
switch by key switch, you can cause fatal
mistake to your machine.
20. If user operates continuously pushing work
or both brake pedal and accelerator pedal
were depressed at the same time, main
electric parts were able to damage.
To Next Page
Loading...
