Supplement for Infinity Delta Series Software
18 Supplement – Infinity
®
Delta Series Software VF10.1
Admission, Transfer, and Discharge
Admitting a patient at the Central Station
1 Select the viewport that corresponds to the room/patient monitor.
2 Click on Admit/Standby.
3 Click on the Demographics tab if it is not already selected.
4 Enter the patient information in the appropriate fields.
5 Click on Apply to confirm your entry.
If you pre-admit a patient to a discharged Delta patient monitor, the monitor exits discharge.
NOTE
To change the patient’s category (adult, pediatric, or neonatal), you must access the Patient
Setup menu at the bedside monitor.
If you change a patient’s category, the weight selection is cleared and must be entered again.
In neonatal mode, additional settings (gestational age and birth weight) are available at the
bedside monitor only. Day of Life and corrected GA values also appear in a read only field.
Entries and changes regarding a patient’s height and weight affect all other monitor menus and
displays that use this information.
For more information on admission at the Delta, see the Instructions For Use for the Delta
monitor.
Dräger recommends that patients be admitted at the Infinity CentralStation.
To Next Page
Loading...
Need help?
General
