Dräger Infinity Delta Series - Display Features

Supplement – Infinity
®
Delta Series Software VF10.1 45
Supplement for Infinity Delta Series Software
The suggested action is to disconnect the duplicate device.
Display Features
etCO2 Monitoring
The etCO2 waveform displays the instantaneous CO
2 concentration. The etCO2 parameter box displays
the following parameters:
– End-tidal CO
2 (etCO2) — The level of CO2 in the airway at the end of expiration.
– Inspired CO
2 (inCO2) — The level of CO2 in the airway during the inspiration phase.
– Respiration Rate (RRc) — The patient’s respiration rate, derived from the etCO2 signal by
calculating a n average rate over the two most recent breaths.
etCO2 Param eter Box
Typical etCO2 parameter box displays are shown below.
A
etCO2 (end-tidal CO2) label and value
B
etCO2 alarm limits
C
inCO2 (inspired CO2) label and value
D
inCO2 alarm limit (upper limit only)
E
Respiration rate label and value
F
Respiration rate alarm limits
NOTE
If alarms are disabled, crossed-out triangle icons appear next to the corresponding parameter values.
NOTE
The patient monitor does not alarm for etCO2 violations until it has established a valid respiratory rate.
A
B
C
D
E
F
inCO2