Description and Intended Use
Dräger PSS
®
Merlin
®
9
Temperature of the monitoring system (Bodyguard
®
II and Connect ECU only).
By pressing the information button of the ECB, a controller is able to scroll between Time of Whistle, Time to Whistle, Pressure,
and Temperature. The Time to Whistle information is the default data displayed on the electronic monitoring system. Additionally,
the time elapsed from activating the electronic monitoring system to ‘operational mode’ can be displayed.
The above information is displayed on the individual channel screens of the ECB and the defaults and data sequence can be
configured to meet the requirement of the end user. Contact Dräger for details.
Additional alert status signals received from the electronic monitoring system are:
Automatic Distress Signal Unit (ADSU) alarm signal (motion sensor).
Distress Signal Unit (DSU) manual alarm signal (panic button).
Voluntary withdrawal.
Each of these signals is differentiated and identified on the ECB by separate illuminated icons.
3.4 Transmitting Information
The ECO is able to activate the following transmissions from the Entry Control Board to each logged on electronic monitoring
system combination:
Acknowledgement of a voluntary withdrawal transmission from a electronic monitoring system.
Selective evacuation signal – evacuation command to a single electronic monitoring system.
Evacuate-all signal – simultaneous evacuation command to all logged-on electronic monitoring systems.
3.5 Manually Recorded Information
Adjacent to each of the channel screens is a rectangular panel area (remarks panel). Using a waterproof marker (e.g. chinagraph
pencil), record any relevant data regarding individuals or teams, including location of the wearer, location of the team, team
reference, etc. If required the board can be photographed to provide evidence from an incident.
To Next Page
Loading...
Need help?
General
