40
This output will activate when any zone tamper alarm occurs for the selected partition(s) and
remain active until the partition is disarmed (alarm silenced) or Bell Time-out occurs.
This output will activate when any zone fault alarm occurs for the selected partition(s) and remain
active until the partition is disarmed (alarm silenced) or Bell Time-out occurs.
Zone Tamper Follow, this output will enunciate when a zone goes into tamper alarm. Any one of
the 64 zones can be selected. If the zone is tampered, the output will activate, when the zone is
restored the output will deactivate. When “Follows + Alarms” is enabled then the output will remain
active until the partition that the zone belongs to is armed.
Zone Fault Follow, this output will enunciate when a zone goes into Fault alarm. Any one of the 64
zones can be selected. If the zone is faulted, the output will activate, when the zone is restored
the output will deactivate. When “Follows + Alarms” is enabled then the output will remain active
until the partition that the zone belongs to is armed.
This output will activate when the selected partition(s) are At-Home armed ([Q][9]), or when the
partition is armed with interior zones bypassed.
This output will activate when the selected partition is armed and interior zones are active.
ZONE TAMPER
(29)
ZONE FAULT
(30)
ZN. TAMP. FOLLOW
(31)
ZN. FAULT. FOLLOW
(32)
ARMED HOME MODE
(33)
ARMED AWAY MODE
(34)
SYSTEM AREA
PGM OUTPUTS
To Next Page
Loading...
