STANDARD are as follows:
preload: 8 turns from fully unloaded;
compression on RH fork leg: 8 clicks from fully
closed;
rebound on LH fork leg: 8 clicks from fully closed
position.
To change preload of the spring inside each fork leg,
turn adjusters (2), with a hexagon wrench,
completely counter clockwise, to obtain fully
uncompressed position.
From this position, adjust the spring preload by
turning the adjuster clockwise.
Every turn corresponds to 1 mm (0.04 in) of spring
preload.
Adjust both fork legs to same
218
To Next Page
Loading...
