Trip time (TRIP 1 TIME)
The instrument panel calculates and shows trip time.
Value is displayed as hhh:mm followed by “TRIP 1
TIME” indication.
The calculation is made considering the time elapsed
since the last reset of Trip time (TRIP 1), average fuel
consumption (CONS.AVG 1) and average speed
(SPEED AVG 1). When TRIP 1 is reset, this value is
reset as well.
The active time counting phase occurs when the
engine is running, even when the vehicle is stopped.
The time count is automatically stopped when the
vehicle is not moving and the engine is and
when the counting active phase
again.
When the reading exceeds 511:00 (511 hours and 00
minutes), the meter is reset and automatically
counting from 0 again.
If (4) is pressed when trip time is displayed,
the instrument panel will activate the warning
"RESET ?" in place of the time. When this warning is
active, Menu scrolling is not possible.
If you press (1) or (2), the instrument panel will
display TRIP 1 TIME again, without the
value.
While if you press (4), value for TRIP 1 TIME
will be reset and the instrument panel will display
TRIP 1 TIME at “0:00”.
Note
If you change the unit of measurement for an
item connected to Speed (and distance) or
Consumption or a the trip time
value will be automatically reset.
Fig 31
78
To Next Page
Loading...
