When pressing (4) within the Menu, “WAIT …”
is displayed for 2 seconds. During this time, Menu
scrolling via (1) and (2) is disabled.
When system is enabled, “ABS-ON” is displayed, the
ABS light (10, Fig 9) turns on to indicate that the ABS
is active and (1) and (2) are enabled.
If the ABS status does not change in 5 seconds, the
instrument panel will replace “WAIT …” message
within the Menu with “ABS-ERR” message blinking
for 3 seconds.
3 seconds:
- if disabling was requested, the instrument panel
automatically shows again “ABS-ON” and the
request can be made again, if required;
- if enabling was requested, the instrument panel
automatically shows again “ABS-OFF” and the
request can be made again, if required.
89
To Next Page
Loading...
