Tips on how to select the sensitivity level
Excellent operation of the EBC system, for all
available levels, is ensured only with OE tyres and/or
with the ones recommended by Ducati and with the
OE final drive ratio. In OE tyres for this
motorcycle are Pirelli Diablo Supercorsa SP in the
following sizes: 120/70ZR17 at the front, 200/60
ZR17 at the rear. The use of tyres of size and
characteristics to the original tyres may alter the
operating characteristics of the system thus making
it unsafe. It is recommended not to install tyres of
size than the ones approved for your
vehicle.
As far as tyres are concerned, in the case of minor
such as, for example, tyres of a
make and/or model than the OE ones, it is necessary
to use the relevant automatic calibration function in
order to restore correct system operation.
As far as the final ratio is concerned, when using a
ratio (which only possible for tracing use)
than the original equipment one, it is recommended
to use the relevant automatic calibration function in
order to restore optimal system operation.
Selecting level 3, the EBC will kick in to ensure the
minimum engine brake possible. Between level 3
and level 1 there are progressively increasing engine
brake levels.
The choice of the correct level mainly depends on
the following parameters:
●
The grip (type of tyre, amount of tyre wear, the
road/track weather conditions, etc.).
●
The characteristics of the path/circuit (bends all
taken at similar speeds or at very
speeds).
●
The Riding Mode.
183
To Next Page
Loading...
