4-1
Chapter 4 Cleaning the Unit
Chapter 4 Cleaning the Unit
• Make sure that you disconnect the power cord from the wall outlet before cleaning.
• Before you use the machine after cleaning, make sure that its surface is completely dry.
Do not touch the power switch
with wet hands.
Otherwise electric hazards may occur.
1. Cleaning Each Part
1-1. Cleaning the conveyance belt and rollers
Clean the belts and rollers while turning them using a cloth moistened with alcohol.
1-2. Cleaning the LCD
Wipe the LCD on the control panel with the dry cloth.
Do not use flammable sprays and solvents during cleaning, etc. of internal
parts of the machine and in the vicinity of the machine.
Doing so could cause build-up of gas inside the machine, which in turn could cause ignition, resulting in re
and explosion.
When using alcohol, exercise precaution against re and ventilate well, and after use, store in a safe
place.
Use of other solvents may damage the rubber rollers and resin inside the machine, resulting in malfunction.
To Next Page
Loading...
Need help?
General
