Duplo DBM-600T

2-40
Chapter 2 Basic Operation
8-7. Using the fold paper holder
When thin paper sags in the folding section, use the fold paper holder. Set the adjustment to the same
position on either side.
Standard position: [B]
1
Loosen the fold paper holder knob
screw.
[A] [B]
2
Move the fold paper holder height
adjustment counterclockwise.
Standard position: [B]
Counterclockwise: The fold paper holder
moves downward and the gap becomes
narrower. [A]
Clockwise: The fold paper holder moves
upward and the gap becomes wider. [B]
8-8. Adjusting the ejection pressure
When a booklet conveyed from the folding section is not ejected smoothly, change the position of the
ejection pressure adjustment lever. Set the lever to the same position on either side.
Standard position: lower
1
Remove the ejection pressure
adjustment lever from the pin.
2
Move the lever to the upper position.