47
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
The manual controls are located on the front of the 2009 Track radiator platform.
To move the 2009 Track using these controls, simply push the levers forward to go forward, pull the levers back to go
backwards, and for turning, operate one lever opposite the other.
RUNNING THE 2009 TRACK USING THE REMOTE CONTROL
A remote control may be used instead of the manual levers. The remote control also has two joysticks on it used to
move the 2009 Track.
STARTING THE ENGINE WITH THE REMOTE CONTROL
1. Start the engine with radio/local switched to local.
2. Turn radio on.
3. Press and hold the start button next to the radio/local switch and switch radio/local switch to radio.
4. Depress the E‑Stop button.
5. Twist E‑Stop to release button and the green light on the remote will light up. (If green light does not
come on retry above procedure)
6. Release the start button.
Remember the track speed must be set on low for a remote start up.
Remote control for the
2009 track
To Next Page
Loading...