Duratech 2009 - Page 98

90
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
PROGRAMMING A REPLACEMENT TRANSMITTER
To program a replacement transmitter, complete the following steps:
1. Power up the R100E Receiver and verify that the
Green Status LED and the Red E‑Stop LED are on
steady.
2. Power up the T100 Transmitter into Programming
Mode by Pressing and holding the RED E‑Stop
button and then the Green Power Button at the
same time. This will power up the T100 into
Programming Mode. The Yellow LED to the right
of the GREEN Power Button will begin ashing
slowly, (once per second).
3. Enter the Programming Password Code by pressing
buttons (functions) (3, 1, 4, 2) and then press the
GREEN Power button once. The Yellow LED to
the right of the GREEN Power Button and the Red
LED to the left of the GREEN Power button will
begin ashing rapidly.
4. Enter the programming values. The programming values for DuraTech are 2266888888. If throttle is
included, use 2266228888.
5. Press and hold the SETUP button on the R100E Receiver (approx. 5 sec.). The Yellow Setup LED will
start ashing slowly while the R100E Receiver enters into programming mode. Once the Yellow Setup
LED on the R100E Receiver begins to ash rapidly, release the SETUP button. The R100E is now ready
to receive the programming information from the T100 Transmitter.
6. Press and release the GREEN Power Button on the T100 to start sending the Programming information
to the R100E Receiver. The Green Link LED on the R100E Receiver will begin to ash, and the Green
Status LED on the R100E Receiver will be ON steady. Wait for the Link LED to stop ashing, for the
Status LED to begin ashing, and for the transmitter to shut off. This signies that the programming
information has been successfully sent from the T100 Transmitter to the R100E Receiver.
7. Momentarily Power OFF the R100E Receiver and wait for 5 seconds, then power up the R100E Receiver
again. The new program settings will now take effect.
8. Press the GREEN Power Button on the T100 Transmitter and observe that the Yellow LED to the right
of the GREEN Power Button of the T100 Transmitter will begin ashing. Also note that the Green Link
LED on the R100E Receiver is ashing and the Green Status LED on the R100E Receiver is on steady.
You are now ready to operate your T100/R100E system.
OUT OF RANGE/LOSS OF SIGNAL
The range of the OMNEX ORIGA is approximately 1,200 feet. Under certain circumstances, such as low or dead
batteries, loss of signal can occur within that distance. In the event that loss of signal occurs, the transmitter will shut
off, and the engine will be shut off by the engine kill circuit.