DynaGen GSC400 Series User Manual

50 of 105
Locked Rotor, HighEngineTemp,
LowOil Pressure, Over Speed, Low
Fuel Level, Oil Level, Low Coolant,
Low Air Pres, Low Hydraulic,
Auxiliary Fail, Low Battery, High
Battery, UnderSpeed, Under Voltage,
Over Voltage, Over Current, Loss of
ECM, EPS Load Fail, Config Fail 1,
Config Fail 2
Warnings: Disable,
HighEngineTemp, LowOil Pressure,
Over Speed, Low Fuel Level, Oil
Level, Fuel In Basin, Auxiliary Warn,
Charger Fault, Low Battery, High
Battery, Under Speed, Under Voltage,
Over Voltage, Over Current,
LowEngine Temp, High Fuel Level,
Config Warn 1, Config Warn 2
Warning Table 1
Events Table 1
Failure Table 2
Warning Table 2
Events Table 2
Events: Disable, EPS Load On, Idle
Running, Service Needed, Not In
Auto, LoBatt InCrank
Set Dummy Load
Load Check Disable, Enable
Bypass Delay 10 – 120s
Load On Point 0 – 500A
Load Off Point 0 – 500A

DynaGen GSC400 Series Specifications

General

Brand	DynaGen
Model	GSC400 Series
Category	Controller
Language	English