91 of 105
Read Only. Allows user to determine current controller mode (and sub-mode). Any active events or
warnings will be displayed up to a maximum of 6.
40100 System operating
mode
0x90
0x93
0x96
0x99
0x9C
R (Read
Only)
The possible controller modes are:
MENU/OFF SLEEP mode 0x90 (144)
OFF mode 0x93 (147)
AUTO mode 0x96 (150)
FAILURE mode 0x99 (153)
RUNNING mode 0x9C (156)
When in controller menu/OFF sleep
mode if the controller is required to go to
the AUTO mode a system disable
command (40098) must be written
followed by system enable command
(40098).
40101 System Sub-state 0 ~ 40 R
The controller sub-mode (if applicable):
19 DLY TO START
20 PREHEATING
21 CRANKING
22 WARM UP
23 CRANK REST
25 COOLDOWN
26 SHUTDOWN
27 IDLE RUNNING
31 IDLE COOL
32 REMOTE START RUN (RSC contacts)
33 Front Panel Run (Manual Run)
34 MODBUS RUN (modbus start
triggered)
35 LOW BATTERY RUNNING
36 EXERCISER RUNNING
0 None of the above. 0 corresponds to none
of the above sub modes of operation.
40102
~
40107
Active Event
message queue
0 ~ 255 R (Read
Only)
A maximum of 6 events/warnings are stored
concurrently. One event/warning per
register. Ensure that controller is not in
sleep mode before reading.
0 READING ABORT (DTC reading)
1 Low Voltage In Crank
2 Charger 1 Fault
3 Need Maintenance
To Next Page
Loading...
