Eaton 9000X - Menu Navigation

9000X AF Drives User Manual
MN04001004E
For more information visit: www.eaton.com 5-3
June 2009
Table 5-3: Navigation Buttons (Continued)
Menu Navigation
Navigation Tips
● To navigate within one level of a menu, use the up and down arrows.
● To move deeper into the menu structure and back out, use the right and left arrows.
● To edit a parameter, navigate to show that parameter’s value, and press the right arrow
button to enter the edit mode. In edit mode, the parameter value will flash.
● When in edit mode, the parameter value can be changed by pressing the up or down
arrow keys.
● When in edit mode, pressing the right arrow a second time will allow you to edit the
parameter value digit by digit.
● To confirm the parameter change you must press the ENTER button. The value will not
change unless the ENTER button is pushed.
● Some parameters can not be changed while the SVX9000/SPX9000 is running. The
screen will display LOCKED if you attempt to edit these parameters while the drive is
running. Stop the drive to edit these parameters. See the appropriate application
manual for identification of these parameters specific to your chosen application.
Main Menu
The data on the control keypad are arranged in menus and submenus. The first menu level
consists of M1 to M8 and is called the Main Menu. The structure of these menus and their
submenus is illustrated in Figure 5-2. Some of the submenus will vary for each application
choice.
Button Description
Left Arrow
• navigation button, movement to left.
• in parameter edit mode, exits mode, backs up one step.
• cancels edited parameter (exit from a parameter edit mode).
• When in “Operate” menu will move backward through menu.
• At end of “Start-Up Wizard”, repeats the “Start-Up Wizard” setup menu.
Right Arrow
• navigation button, movement to right.
• enter parameter group mode.
• enter parameter mode from group mode.
• When in “Operate” menu will move forward through menu.
Up and Down Arrows
• move either up or down a menu list to select the desired menu item.
• editing a parameter/password, while the active digit/character is scrolled.
• increase/decrease the reference value of the selected parameter.
• in the “Operate” menu, will cause the display of the current reference
source and value and allow its change if the keypad is the active
reference source. Used to set the password (if defined) when leaving
the “Operate” menu.
• scroll through the “Active Faults” menu when the SVX9000/SPX9000 is
stopped.