6 UPS operating instructions
66..11 AAbboouutt UUPPSS ooppeerraattiioonn
Before UPS startup, make sure that all installation work has been completed, and that the initial startup
has been performed by qualified service personnel authorized by Eaton. Before the initial startup,
examine all electrical connections to make sure that the system has been successfully installed and
correct operation is possible.
Read the operating instructions carefully before operating any control devices, and have a full
understanding of UPS operations.
The UPS can operate at any of the following three rated voltages: 220/380, 230/400, or 240/415 VAC.
Before you operate the UPS, confirm the rated voltage and frequency of the UPS from Settings→System
Information on the control panel. If the UPS must operate at other voltages or frequencies, contact your
local Eaton representative.
The UPS is not a measurement device. All measurements displayed are approximate values.
66..22 CCoonnttrrooll ppaanneell oovveerrvviieeww
The control panel is used to set up and control the UPS, and to monitor UPS operation.
Figure 34. Control panel and UPS status indicator lights
1. UPS status indicator lights 2. Control panel
EATON 93T USER’S AND INSTALLATION GUIDE 614-40270
-
December 2023 www.eaton.eu 6611
To Next Page
Loading...
