Eaton BladeUPS - Page 2

Eaton reserves the right to change specifications without prior notice. Modbus is a registered trademark of Schneider Automation, Inc.
MOXA is a registered trademark and MGate is a trademark of MOXA, Inc. Spiralock is a registered trademark of Spiralock Corporation.
KIRK is a registered trademark of Kirk Key Interlock company, LLC, a subsidiary of Halma plc. National Electrical Code and NEC are
registered trademarks of National Fire Protection Association, Inc. ERIFLEX and FLEXIBAR are registered trademark of Erico International
Corporation. All other trademarks are property of their respective companies.
©Copyright 2007-2020 Eaton, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the
express written approval of Eaton.
Class A EMC Statements
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
ICES-003
This Class A Interference Causing Equipment meets all requirements of the Canadian Interference
Causing Equipment Regulations ICES-003.
Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel
brouilleur du Canada.
EN 62040-2
Some configurations are classified under EN 62040-2 as “Class-A UPS for Unrestricted Sales
Distribution.” For these configurations, the following applies:
WARNING
This is a Class A-UPS Product. In a domestic environment, this product may cause radio interference,
in which case the user may be required to take additional measures.
Eaton, BladeUPS, and X-Slot are registered trademarks Eaton Corporation or its subsidiaries and
affiliates. Phillips and Pozidriv are a registered trademarks of Phillips Screw Company. National
Electrical Code and NEC are registered trademarks of National Fire Protection Association, Inc. All
other trademarks are properties of their respective companies.
©cOPYRIGHT 2007–2016 Eaton Corporation, Raleigh NC, USA. All rights reserved. No part of this
document may be reproduced in any way without the express written approval of Eaton Corporation.