Eaton BladeUPS - Communication Options

110 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 75. Installing Communication Cables
2. Connect the cables to the appropriate location. See 6.3 Communication Options or
6.6 Control Terminalsfor detailed information.
See for detailed information.
3. Route and tie the cable(s) out of the way.
4. Continue to to start up the UPS.
66..33 CCoommmmuunniiccaattiioonn OOppttiioonnss
The BladeUPS has serial communication capabilities through the DB-9 communication port or through an X-Slot
card in one of the available bays.
The UPS supports two serial communication devices according to the following table:
Table 16. Supported Communication Devices
Independent Multiplexed
X-Slot 1 Communication Bay X-Slot 2 Communication Bay
DB-9 Communication Port
Any X-Slot card Any X-Slot card Not in use
Any X-Slot card
Eaton Relay Interface Card
Powerware Hot Sync CAN Bridge Card
Available
Any X-Slot card
Not in use Available
Communication Options