Eaton BladeUPS - User Settings

Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 97
Table 12. Menu Map for Display Functions
Main Menu Submenu
Display Information or Menu Function
UPS Status
System Normal | High Efficiency Power: % /
Battery Resting | Battery Floating UPS in Parallel Mode /
Parallel Unit Number x / Units on CAN Bus / Units on Load
Event Log Displays up to 100 events and alarms
Measurements
For more
information about
measurements, see
the metering
section.
Parallel
System
kW [by unit] / kW [Parallel total]
Output Voltage L-N and L-L / Current / Frequency / Power kW / Power kVA / Power pf
Battery Voltage / Current / Runtime
Input
Voltage L-N and L-L / Current / Frequency
Load
Receptacle
Outlet Voltage / Outlet Current / Outlet Power kW / Outlet Power kVA / Outlet Frequency
Control Go to Bypass
Mode
Transfers the UPS system to internal Bypass mode
When this command is active, the option changes to Go to Normal Mode.
Start Battery
Test
Schedules a battery test. The battery test may not start immediately.
Display Test Four different selectable tests for the front panel functions: the LEDs cycle through, the
alarm beep sounds, the backlight turns off and on, and the pixels scroll through to test the
LCD.
Settings User Settings Options for user-defined settings (see Table 13 for details).
Service
Settings
Not available.
Identification Type / Part Number / Serial Number / Firmware / Display / System Display / CAN Bridge
Turn UPS On/Off On and Off
Options
Turn UPS Off / Turn System On / Turn System Off
55..55 UUsseerr SSeettttiinnggss
Table 13 displays the options that you can change.
Table 13. User Settings
Description
Available Settings Default Setting
Set Date and Time
Set Year, Month, Day
Date: mm/dd/yyyy
Set Hours, Minutes
Time is a 24-hour clock.
01/01/2003
00:00
Display Contrast Adjust contrast with up/down arrow buttons. Moderate
Change Language
Select Language
Available languages depend on model and languages
installed.
English
User Settings