78 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 63. BladeUPS Module Rear Panel (Standalone UPS Shown with Hardwired Terminal Block)
NOTE The load connector breaker controls the load connector only, not the output power
terminal block connection.
44..1144 NNeeww MMuullttiippllee PPaarraalllleell UUPPSS IInnssttaallllaattiioonn
CAUTION
Only qualified service personnel (such as a licensed electrician) shall perform the electrical installation. Risk of
electrical shock.
NOTE Do not make unauthorized changes to the UPSs; otherwise, damage may occur to your
equipment and void your warranty.
To install two to six UPSs in a new parallel configuration:
1. Verify that the UPSs to be paralleled are installed in individual rail kits in a rack containing a BladeUPS Bar.
New Multiple Parallel UPS Installation
To Next Page
Loading...
