84 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 68. Connecting UPSs to the BladeUPS Bar (Bottom Entry Shown)
44..1155 SSiinnggllee PPaarraalllleell RReeaaddyy UUPPSS IInnssttaallllaattiioonn
CAUTION
Only qualified service personnel (such as a licensed electrician) shall perform the electrical installation. Risk of
electrical shock.
NOTE Do not make unauthorized changes to the UPSs; otherwise, damage may occur to your
equipment and void your warranty.
To install one UPS in a parallel-ready configuration:
1. Verify that the UPS is installed in a rail kit in a rack containing a BladeUPS Bar.
2. Switch off utility power to the distribution point where the parallel-ready UPS system will be connected.
Be absolutely sure there is no power.
3. Verify that all circuit breakers are in the OFF (O) position.
Single Parallel Ready UPS Installation
To Next Page
Loading...
