64 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
• Tighten the top panel screws.
8. Replace the trim:
• Locate the top panel trim assemblies and the 12 screws that you removed previously.
• Replace the outside pairs of trim screws on the first trim assembly, and then replace the interior trim
screws.
• Repeat to install the second trim assembly.
9. Replace the two upper side panels:
• Locate the two upper side panels and the key.
• Slide the bottom lip of the first panel into the track above the bottom panel.
• Push the panel forward until it is flush with the rack frame.
• Snap the panel into the latches.
• Lock the upper side panels with the key.
• Repeat to install the second panel.
10. If installing optional EBM(s), see the EBM Installation section.
Otherwise, continue to the UPS Setup section.
NOTE 1 If you are installing the EBM with a new UPS at the same time, use the UPS user’s
guide to install both the UPS and the EBM.
NOTE 2 Mounting rails are required for each individual cabinet.
44..88 UUPPSS SSeettuupp
The UPS comes with all hardware required for installation in a standard EIA or JIS seismic rack-mount
configuration with square and round mounting holes. The rail assemblies adjust to mount in 48-cm (19-inch)
racks with front to rear rail distances from 61 to 76 cm (24 to 30 inches) deep.
44..99 CChheecckkiinngg tthhee UUPPSS AAcccceessssoorriieess
Verify that the following items are included with the UPS:
• UPS front cover
• Communication terminal block connectors:
– (3) two-pin connectors
– (2) two-pin connectors with jumpers
– (1) three-pin connector
• (2) wire saddles
• Communication cable (DB-9/DB-9)
• Documentation and software tools
– Software Suite CD
– BladeUPS: Documents, Firmware, and Installation Video CD
– This user’s guide
UPS Setup
To Next Page
Loading...
