Eaton BladeUPS - Hardwired Installation

Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 75
Figure 60. BladeUPS Module Rear Panel (Standalone UPS Shown with IEC 309-60A Output Power Cord)
Load
Connector
Breaker
Input
Breaker
Battery
Breaker
Load
Connector
REPO (NC)
REPO (NO)
Communication Port
Ground
Bonding
Screw
UPS
Battery
Connector
X-Slot Communication Bay 1
X-Slot Communication Bay 2
Output Power Cord
Input Power Cord
Surge
Protection
(leave
installed)
NOTE The load connector breaker controls the load connector only, not the output power cord.
44..1133 HHaarrddwwiirreedd IInnssttaallllaattiioonn
WARNING
Only qualified service personnel (such as a licensed electrician) shall perform the electrical installation. Risk of
electrical shock.
Hardwired Installation