Eaton BladeUPS - Page 33

Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 19
CChhaapptteerr 33 PPrreeaasssseemmbblleedd SSyysstteemm IInnssttaallllaattiioonn
33..11 PPrreeaasssseemmbblleedd SSyysstteemm IInnssttaallllaattiioonn
The preassembled system is shipped with the BladeUPS Bar, wireway, and BladeUPS modules already
installed. For configurations with five and six UPS systems, some batteries are shipped uninstalled for better
weight distribution. In addition, the optional Maintenance Bypass Module (MBM) can also be installed and
shipped in a preassembled BladeUPS cabinet.
This chapter explains:
• Equipment inspection
• Floor loading specifications
• Moving and unloading the system
• Preassembled system setup
• Installing the input and output wiring
• Installing UPS internal batteries
• Extended Battery Module (EBM) setup and installation (optional)
• Initial startup
NOTE For instructions on how to connect or to fully install the optional MBM, refer to the
Eaton® BladeUPS® Maintenance Bypass Module User’s Guide.
33..22 IInnssppeeccttiinngg tthhee EEqquuiippmmeenntt
If any equipment has been damaged during shipment, keep the shipping cartons and packing materials for the
carrier or place of purchase, and file a claim for shipping damage. If you discover damage after acceptance, file
a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with the carrier within 15 days of receipt of the
equipment; 2) Send a copy of the damage claim within 15 days to your service representative.
33..33 TToooollss RReeqquuiirreedd
To assemble the components, you may need the following tools:
• Medium flat-bladed screwdriver
• Short- and long-handled #2 Phillips
®
screwdriver
• 6-inch extension bar (or longer)
• Ratcheting socket wrench and socket for 3/8- inch and 10/24-sized screws
• 7 mm, 8 mm wrench or socket
• Adjustable Crescent wrench
• Utility knife
• Adjustable pliers
• Forklift or pallet jack
• Step ladder
NOTE Use safety best practices when standing on a ladder.